When NMEA-0183 output is enabled, a subset of NMEA-0183 messages can be output to external instruments and equipment connected to the receiver serial ports. These NMEA-0183 messages let external devices use selected data collected or computed by the GNSS receiver.
All messages conform to the NMEA-0183 version 3.01 format. All begin with $ and end with a carriage return and a line feed. Data fields follow comma (,) delimiters and are variable in length. Null fields still follow comma (,) delimiters, but contain no information.
An asterisk (*) delimiter and checksum value follow the last field of data contained in an NMEA-0183 message. The checksum is the 8-bit exclusive of all characters in the message, including the commas between fields, but not including the $ and asterisk delimiters. The hexadecimal result is converted to two ASCII characters (0–9, A–F). The most significant character appears first.
The following table summarizes the set of NMEA messages supported by the receiver, and shows the page that contains detailed information about each message.
| Message | Function |
|---|---|
| ADV | Position and satellite information for RTK network operations |
| DTM | Datum reference information |
| GBS | GNSS satellite fault detection (RAIM support) |
| GGA | Time, position, and fix related data |
| GLL | Position data: position fix, time of position fix, and status |
| GNS | GNS Fix data |
| GRS | GRS range residuals |
| GSA | GPS DOP and active satellites |
| GST | Position error statistics |
| GSV | Number of SVs in view, PRN, elevation, azimuth, and SNR |
| HDT | Heading from True North |
| LLQ | Leica local position and quality |
| PFUGDP | A proprietary message containing information about the type of positioning system, position, number of satellites and position statistics |
| PTNL,AVR | Time, yaw, tilt, range, mode, PDOP, and number of SVs for Moving Baseline RTK |
| PTNL,BPQ | Base station position and position quality indicator |
| PTNL,DG | L-band corrections and beacon signal strength and related information |
| PTNL,GGK | Time, position, position type, and DOP values |
| PTNL,PJK | Time, position, position type, and DOP values |
| PTNL,PJT | Projection type |
| PTNL,VGK | Time, locator vector, type, and DOP values |
| PTNL,VHD | Heading Information |
| RMC | Position, Velocity, and Time |
| ROT | Rate of turn |
| VTG | Actual track made good and speed over ground |
| ZDA | UTC day, month, and year, and local time zone offset |
To enable or disable the output of individual NMEA messages, do one of the following:
Note – The position output by the receiver is the Antenna Phase Center position. You may want to reduce this position to a reference position elsewhere. If so, you should account for any tilt of the antenna in such a reduction. The settings for the Antenna Measurement Method and Antenna Height are not applied to the position outputs.
For a copy of the NMEA-0183 Standard, go to the National Marine Electronics Association website at www.nmea.org.
联系客服
