清晨的贝雷帽(实物图在24，36，55楼）

想给自己织一顶贝雷帽，搜了搜样子，觉得这个又简单又好看。试着翻译了一下。回头实践一下。http://www.ravelry.com/patterns/library/early-morning-beret
http://knitbot.com/2010/11/20/simple-beret-pattern/
Here is the pattern for the simple worsted weight beret I posted earlier this week.

Early Mornings Beret – now that it’s cold here in Maine, I find myself putting a hat on first thing in the morning while I wait for the wood stove to get going!
Yarn: The Fibre Company Knightsbridge (70% alpaca, 30% merino, 100 yards, 50 gms), but any worsted weight will do!
2 skeins (I had a partial skein left over, so probably around 170 yards)
Gauge: 20 x 28
Needles: US 7 16″ circular, then set of double pointed needles for the final decrease rounds.
With circular needle, cast on 88 sts.  Join for working in the round, being careful not to twist sts, and placing a marker at the beginning of the round.
Work in k1, p1 rib for 8 rounds, or desired length.
Knit 1 round.
Increase round: * K2, m1; repeat from * to end of round. (132 sts)
(Note – m1 is make 1: make one stitch by lifting bar between stitches from back to front with the left needle and than knitting through the front of it with the right needle.
Continue in Stockinette st, knitting all rounds, until hat measures 5″ from cast on edge, or desired length.
Setup round: *K12, place marker; repeat from * to end of round.
Decrease round: *K to 2 sts before m, ssk, slip marker; repeat from * to end of round.
(Note – ssk is slip slip knit: slip the first stitch as if to knit, slip the second stitch as if to knit, then slide the left- hand needle into the front part of both stitches and knit them together. There are all kinds of on-line tutorials if you google ssk.)
Repeat this decrease round every other round until 11 sts remain.
(Note – switch to double pointed needles when sts can no longer stretch around circular)
Next round: *ssk; repeat from * to end of round, k1.
Break yarn, pull tail through remaining sts and weave tail into wrong side of hat.  Weave in any other tails.  Block.

简而言之:

美国7号（直径4.5mm)16英寸（40.64厘米）环形针，两幅棒针（缩针后使用）

1.起88针，螺纹织8圈或者自己喜欢的高度，然后织一圈平针
2.织两针加一针，重复这样一圈下来变成132针。平针圈织若干行，大概5英寸高，12.7厘米(从帽边量）。或者喜欢的高度
  加针：左针从后面挑起两针中间的横杠到左边针上，然后右边针把挑起的这针织成下针。
3.每12针做一个记号，也就是把132针平分成11份
4.记号前两针并一针（右边针依次把左边针上的两针挑到右边针上来，然后左边针从前面把两针一起织起来变成一针，有各种方法的两针并一针，随便哪种都行）每隔一圈进行一圈的并针。直到还剩下11针。
5.最后剩下11针的时候，最后一圈这样织：滑两针并一针，不断重复，直到到最后一针织一针。断线打结。结束。