Insufficient memory for system transfer 传送系统文件的存储空间不足
Insufficient room in root directory 在根目录中空间不够
Erase files from root and repeat CHKDSK 从根目录中删除文件,并重复CHKDSK命令
Insufficient space on disk 磁盘空间不足
Insufficienft stack space 堆栈空间不足
Internal stack overflow 内部堆栈溢出
Invalid baudrate specified 说明了无效的波特率
Invaaalid characters in volume label 卷标中有无效字符
Invalid current directory 无效的当前目录
Invalid date 无效的当前日期
Invalid device parameter from driver 驱动器的无效设备参数
Invalid directory 无效的目录
Invalid disk change 无效的磁盘更换
Invalid drive in search path 搜索路径中有无效驱动器
Invalid drive or filename 无效的驱动器或文件名
Invalid drive specification 无效的驱动器说明
Invalid ienvironment size specified 无效的环境大小说明
Invalid format file 无效的格式文件
Invalid filename or file not found 无效的文件名或找不到文件
Invalid number of parameters 参数个数说明
Invalid partition table 无效的分区表
Invalid path,not directoru or directory not empty
无效路径,不是目录或目录不空
Invalid path or paramefter 无效的路径或参数
Invalid subdirectory 无效的子目录
Invalid switch 无效的开关
Invalid switch character 无效的开关字符
Invalid syntax 无效的句法
Invalid time 无效的时间
Invalid volume labvel 无效的卷标
提示信息 说明
LABEL not found LABEL 未找到
Last backuptarget not installed 未安装最后的备份目标软盘
Last file not backed up 未备份最后的文件
Line too long 行太长
Lock voilation 违反锁定
Logical DOS drive created,drive letters changed or added
逻辑DOS驱动器已建立,驱动器字符已被改或加
LPT#:nit rerouted LPT#: 没有改变路线
LPT#:rerouted to COMn: LPT#:改变路线到COMn:
LPT#:set for 80 LPT#:设置为80
LPT#:SET FOR132 LPT#:设置为132
提示信息 说明
Make sure a diskette is inserted into the drive and the door
is closed 查明软盘是否已插入驱动器,驱动器门是否被关闭
Maximum available space is xxxx cylinders at cylinder yyyy
最大可用空间是磁道柱面yyyy上的xxxx个 磁道
Maximum number of logical DOS drive installed
已安装的逻辑DOS驱动器的最大数
Memory allocation error 存储分配错误
Missing operating system 缺少操作系统
提示信息 说明
No extended DOS partition to frlrtr 没有可删除的扩充DOS分区
No files found 文件没找到
No files replaced 没有文件被替换
No fixed disks present 硬盘不存在
No partition tofelete 没有分区要删除
No partutuon make active 未能激活分区
No path 无路径
No primary DOS partition to delete 没有主DOS分区供删除
Noretry on parallel printer time-out 并行打印机超时,勿再试
No room for system on destination disk 在目标磁盘上没有存放系统文件空间
No room in directory tor file 目录中无文件空间
No room in root directory 根目录中无空间
No source drive specified 没有指定源驱动器
No space to create a DOS partition 没有空间建立DOS逻辑分区
No space to create logic drive 没有空间建立逻辑驱动器
No subdirectories exist 不存在子目录
NO system on defalut drive 缺省驱器上无系统文件
No target drive specified 没有指定目标驱动器
NON_DOSdiskette 非DOS盘
Not-system disk or disk error replace and strike a key when
ready 非系统磁盘或磁错误,更换一张盘后,键入任意键
Not able to back up file 不能备份文件
Not able to restore file 不能恢复文件
Not able to memory 内存不够
Not enough room to merge the entire file 没有足够的空间合并整个文件
Not found 未找到
提示信息 说明
Only non-bootable partition exist 只存在不可引导的分区
提示信息 说明
Parameter not compatible 参数不兼容
Parameter not compatible with fixed disk 参数与硬盘不兼容
Partition is already active 分区已被激活
Partition xx made active 分区XX被激活
Path not found 路径未找到
Path too long 路径太长
Pathname too long 路径名太长
Please replace original diskette in drive A: and press
在A驱动器中更换源盘,并按键
Press any key to begin copying files 按任意键,开始拷贝文件
Press any key to begin recovery of files on drive x:
按任意键,开始恢复X驱动器中的文件
Press any key to replacing files 按任意键,开始替换文件
Primary DOS partition alresdy exists 主DOS分区已经存在
Primary DOS partition deleted 主DOS分区被删除
Primt queue is full 打印队列已满
Printer error 打印机出错
Print queue is wmpty 打印队列为空
Probable non-DOS disk 可能是非DOS盘
Program terminted normally 程序正常结束
Program too big to fit in memory 程序太长,不能放到内存中
提示信息 说明
Replace (y/n) 是否要替换文件
Replacing 正在替换指定文件
Request logical drive size exceeds the maximum available space
需要的逻辑驱动器的大小超出了最大可用空间
Restore folr sequence error 恢复文件顺序出错
restoring file from drive x 从驱动器x中恢复文件
Restoring files form drive y 从驱动器y中恢复文件
提示信息 说明
Sector size adjusted 调整扇区长度
Sector size too large in file 在文件中扇长度太大
SHARE already required SHARE已安装
Sharing violation 违反共享
Specified drive does not exist 指定垢驱动器不存在
Source diskette bad or incompatible 源盘坏或不兼容
Syntax eror 语法错误
System files restored 系统文件已恢复
system transfered 系统文件已传送
system will now restart, insert DOS diskette in drive A:
系统将重新启动将DOS盘插入A驱动器中
提示信息 说明
Target cannot be used for backup 目标盘不能用于备份
Target diskette unusable 目标盘不能使用
Tsrget diskett may be unusable 目标盘可能不可用
Target diskette write protected,correct,then strike any key
目标盘写保护,校正后按任意键
Target is full 目标盘满
Terminate by user 被用户终止
The current active partition is x 当前活动分区是x
The last file was not restored 最后一个文件未被恢复
Too many external symbol,limit 510 per module
外部符号太多,每个模块最多有510个外部符号
Too many files open 打开的文件太多
Too many name entives 输入的名字太多
Too many overlays 覆盖太多
Total disk space is xxxx cylinders 磁盘空间共有xxxx个柱面
提示信息 说明
Unable to create directory 不能建立目录
Unable to write BOOT 不能对BOOT进行区写操作
Unrecognized switch error :xxxx 不能识别的开关错误
Unrecoverable error on directory 目录上有不可恢复的错误
Unrecoverable file sharing error 不可恢复的文件共享错误
Unrecoverable read error on drive x 驱动器上不可恢复的读错误
Unrecoverable read error on source 源盘上不可恢复的读错误
Unrecoverable write error on target 目标盘上不恢复的写错误
提示信息 说明
VERIFY in ON/OFF 校验打开/关闭
Volum label (11 characters,ENTER for none) 输入卷标(11个字符,若不设置,按键)
提示信息 说明
Warnung! All data on non-removable disk x will be lost
proceedwithformat(Y/N)?
警告!不可拆卸的磁盘驱动器x上的数据将丢失,继续进行格式化吗?(Y/N)
Warning! Dats in extended DOS partitile could be
DESTORYED,Doyou wishxontinue...? 警告!扩充DOS分区的数据可能被破坏,是否愿意继续吗?
Warning! Data in the primary DOS partition could be DESTORYED,
Do youwish continue...? 警告!DOS分区里的数据将被破坏,继续吗?
Warnung! directory full 警告!目录满
Warning! Diskette is out of ssequence 警告! 磁盘顺序乱
Warning! File xx is a read only file 警告! 文件xx是一个只能读文件
Wsrning! File xx was changed after it was back up
警告!文件xx在备份后,发生了改变
Warning! File in the target drive d:\BACKUP directory will be
erasedstrike any key when ready
警告!目标驱动器d:\backup目录内的文件将被删除,按任意键
Warning! File in target drive dL\JB)oot directory will bee
erased 警告d:根目录下的文件将被删除
Wsrning! No file were found to backup 警告!未找到备份文件
Warning! No files were found to restore 警告!未找到恢复文件
Warning! Target full 警告!目标已满
Warning! The partition marked active is out bootable
警告!被标记为活动的分区不能引导
提示信息 说明
xxxxxx bytes disk apace freed 有xxxxxx字节的空间可用
xxx file added 文件xxx已被追加
xxx lost cluster found in yyy chains 在yyy链中找到了丢失的xxx簇