大家好！安信可科技新AT固件发布，更稳定，支持智能连接技术！
在透传模式下，即使掉电，上电后仍然可以自动恢复透传模式，即使在大数据量下也不崩溃重启。
这是真正意义上的透传模式！
由于AT指令变动非常大，和过去的AT固件不兼容，请先查阅附件中的手册，支持更多指令！
目前支持：
安信可智能连接技术AI-LINK
乐鑫智能连接技术ESP-TOUCH
微信智能连接技术AIR-KISS
我们的Smart LINK APP：无需直接连接模块即可配置模块。
特性简介以及使用方法说明：
a. install ai-link.APK to cell phone.
b. Burn v0.9.5.2 AT Firmware to 0x00000.
c. enjoy AT command.
Before using AT command, please read documents.
FAQ:
How to use ai-thinker's smart link technology?
EXECUTE
AT+CWSMARTSTART=0
And use smart link software push SSID and password over the ai-link technology.
How to control GPIO and read ADC?
AT+CIPAP? AT returns the IP address of the module current AP mode + CIPAP = "192.168.4.2" Setting the IP address of the AP mode
AT+CIPSTA? View IP address AT STA mode + CIPSTA = fixed IP "192.168.1.2" STA mode setting above operations are effective immediately without restarting
AT+CIPAPMAC query the current MAC address of the AP mode settings for the current MAC address of the AP mode AT + CIPAPMAC =? "1a: fe: 34: 9e: 34: a9"
AT+CIPSTAMAC exercise MAC address AT STA mode + CIPSTAMAC =? "18: fe: 34: 9e: 34: a9" AP mode settings for the current MAC address
AT+CIOADC command reads the ADC value Note: ADC input voltage range is between 0V to 1V! 0 to 1024,10 bit precision
AT+CIOREAD command reads the GPIO AT + CIOREAD = 0 reads GPIO0 level assumptions GPIO0 is high, it will return 1: HIGH, otherwise it returns 0: LOW GPIO range of digital, GPIO0, GPIO16 can
AT+CIOWRITE command to set the GPIO AT + CIOWRITE = 0,0 setting GPIO0 level is low AT + CIOWRITE = 16,1 set of high level GPIO16
baud rate support wider, 110,300,600,1200,2400,4800,9600,19200,38400,57600,74880,115200,230400,256000,460800,921600
AT+CIOBAUD=115200,8,1,0,3
OR
AT+CIOBAUD=115200
can set baudrate you want
另外我们最新的模块ESP-12具有FCC与CE认证，品质保证！
|
|
